How to Replace Rear Brakes and Caliper 08-17 Honda Accord
Difficulty: Advanced · About 120 min · Honda Accord
Replace the rear brake caliper and pads on a 2008–17 Honda Accord, reconnecting the brake hose and fully bleeding the hydraulic circuit before driving.
Tools you will need
- Floor jack
- Jack stands
- Socket set
- Drain pan
- Brake line tool
- Torque wrench
- Brake bleeder hose
Parts and supplies
- Rear brake caliper
- Brake pads
- Caliper hose sealing washers
- Brake fluid specified for the vehicle
Steps
Raise the vehicle and remove the wheel
Loosen the lug nuts on level ground, raise and support the rear securely, then remove the wheel and set it aside.
Remove the pads and caliper
Retract the piston slightly, remove the caliper fasteners, and lift the caliper clear. Support the hose and catch fluid in a pan while disconnecting the brake line.
Remove bracket and rotor
Remove the bracket bolts and rotor retaining screws, then take off the rotor. Clean the hub face and inspect the brake slides and backing plate.
Install rotor and brake hardware
Clean the replacement rotor and fit it to the hub. Reinstall the bracket and pads, tightening fasteners to vehicle specification.
Install the replacement caliper
Connect the hose with new sealing washers and tighten the banjo fitting to specification. Secure the caliper, hose clip, and slider hardware, checking for twists or tension.
Bleed the brake circuit
Bleed the caliper and affected hydraulic circuit using the vehicle sequence. Keep the reservoir filled, continue until fluid is clear and bubble-free, and inspect every connection for leaks.
Reinstall the wheel and test
Mount the wheel and torque the lug nuts to specification in a crossing pattern. Pump the pedal until firm, inspect fluid level, then test carefully at low speed.
Check your vehicle’s repair manual for exact specifications and fit.