How to Replace Rear Window Motor 05-16 Toyota RAV4

Difficulty: Intermediate · About 100 min · Toyota Rav4

Replace the rear power window motor on a 2005–2016 Toyota RAV4 by removing the door trim, supporting the glass, and transferring the regulator before testing the window.

Steps

1. Remove the rear door panel

   Unclip the switch bezel and disconnect its connector. Remove the handle and pull trim screws, release the panel clips, lift the panel away, and disconnect the handle cables.

2. Support the glass and remove the motor

   Peel back the vapor barrier carefully and tape the raised glass in place. Disconnect the motor lead, loosen the glass-to-regulator bolts, and remove the regulator assembly; then take out the T25 motor screws.

3. Transfer the motor to the regulator

   Slide the replacement motor onto the regulator drive and install its retaining screws. Check that the motor sits flush and its wiring connector is accessible.

4. Reinstall the regulator and glass

   Guide the regulator into the door channel and hang it on its fastener. Lower the glass onto the regulator, tighten its mounting bolts, reconnect the motor lead, and restore the vapor barrier.

5. Reassemble and test the window

   Reconnect the handle cables and refit the door panel, switch, and trim. Cycle the window through its travel and confirm it moves evenly before finalizing the panel clips.

Check your vehicle’s repair manual for exact specifications and fit.