How to Replace Washer Fluid Reservoir 07-10 Hyundai Elantra
Difficulty: Intermediate · About 70 min · Hyundai Elantra
Replace the washer fluid reservoir on a 2007–2010 Hyundai Elantra by freeing the bumper cover, transferring the pump and hoses, then refilling and checking for leaks.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Plastic Fastener Remover
- 7mm Socket
- Drain Pan
- 10mm Socket
- Ratchet
Parts and supplies
- Washer fluid reservoir
- Washer fluid
Steps
Remove the front bumper cover
Switch off the ignition and disconnect the fog-light connectors if fitted. Remove the air-collector fasteners, bumper retainers, and corner screws. Release the lower underbody clips, then pull the cover out of the fender and headlamp guides without forcing the locking tabs.
Disconnect the reservoir
Place a drain pan beneath the washer tank. Unplug the pump, disconnect the washer hose, and allow the fluid to drain. Release the hose and wiring from the reservoir clips, remove its two mounting bolts, and slide the tank off its mounting stud.
Install the replacement reservoir
Seat the new tank on its mounting stud and reinstall both mounting bolts. Reconnect the pump inlet, washer hose, and electrical connector, then secure the wiring and hose in their retaining clips. Refill the reservoir with suitable washer fluid.
Reinstall the bumper cover and test
Align the cover with its fender and headlamp guides and press its tabs into place. Reconnect the fog lights, reinstall the corner screws and retainers, and refit the air collector and lower trim. Test the washers and inspect the reservoir and pump seal for leaks.
Check your vehicle’s repair manual for exact specifications and fit.