How to Replace Washer Fluid Pump 05-11 Honda Civic
Difficulty: Beginner · About 90 min · Honda Civic
Replace the windshield washer pump on a 2005–2011 Honda Civic by removing the bumper cover for access. Catch the fluid, reconnect the hose and plug securely, and verify the spray pattern before closing up.
Tools you will need
- Floor jack
- Jack stands
- Trim tool set
- Phillips head screwdriver
- T35 Torx socket
- Drain pan
Parts and supplies
- Windshield washer pump
- Washer fluid
Steps
Remove the bumper cover
Support the car safely if needed, remove the splash-shield clips and wheel-edge screw, then release the grille shield and bumper fasteners. Pull the cover forward without stressing its tabs.
Remove the failed pump
Place a drain pan below the reservoir, pull the pump from its grommet, and let the fluid drain. Disconnect the electrical plug and washer hose.
Install the replacement pump
Connect the hose and wiring, then press the pump securely into the reservoir grommet. Refill the reservoir with suitable washer fluid.
Reinstall the bumper and test
Seat the bumper cover and reconnect its shields, clips, and fasteners. Operate the washers and check that the pump runs, the hose stays connected, and fluid reaches the windshield.
Check your vehicle’s repair manual for exact specifications and fit.