How to Replace Rear Brakes 2007-2009 Saturn Aura
Difficulty: Moderate · About 90 min · Saturn Aura
Replace the rear brake pads and rotors on the Saturn Aura shown. The procedure covers removing the caliper and bracket, cleaning the rotor mounting face, and reassembling the brake; inspect the caliper and follow the vehicle’s brake service specifications.
Tools you will need
- 19mm socket
- 14mm wrench
- 13mm socket
- brake caliper hanger
- wire brush
Parts and supplies
- Rear brake pads
- Rear brake rotors
Steps
Remove the wheel and caliper
Chock the front wheels and safely raise and support the rear of the vehicle. Remove the wheel. Remove the two 14mm caliper bolts, lift the caliper off, and support it so its weight does not hang from the brake hose.
Remove the bracket and rotor
Remove the two 13mm caliper bracket bolts and take off the bracket and pads. Slide the rotor off. If replacing the rotor, clean rust and debris from the hub face so the new rotor seats flat.
Fit the brake parts
Install the replacement rotor and pads, checking the pad hardware and contact surfaces. Refit the caliper bracket and caliper in their original positions and tighten fasteners to the vehicle specification.
Reassemble and verify
Refit the wheel and lower the vehicle. Before driving, pump the brake pedal until it feels firm, check brake fluid level, and perform the proper bedding procedure for the installed pads and rotors.
Check your vehicle’s repair manual for exact specifications and fit.