How to Change Oil 02-08 Dodge Ram 1500 5.7L Hemi
Difficulty: Beginner · About 60 min · Dodge Ram
Change the engine oil and filter on a 2002–2008 Dodge Ram 1500 with the 5.7L Hemi, using the specified oil grade and quantity and checking for leaks after the engine has circulated the new oil.
Tools you will need
- Funnel
- 13mm Socket
- Oil Filter Wrench
- Torque Wrench
- Drain Pan
- Ratchet
- Cloth Rags
- Floor Jack
- Jack Stands
Parts and supplies
- Engine oil
- Oil filter
- Drain-plug seal
Steps
- Raise the truck and drain the oil
Park on level ground, chock the wheels, and raise the truck at approved lift points before supporting it on jack stands. Place a drain pan under the oil pan, remove the drain plug, and let the oil drain fully before reinstalling the plug to specification.
- Remove and inspect the oil filter
Move the catch pan beneath the filter and loosen it with a filter wrench. Wipe the mounting surface clean and make sure the old gasket has not stuck to the engine.
- Install the replacement filter
Coat the new filter gasket with a thin film of fresh oil and thread the filter on by hand. Tighten it according to the filter manufacturer's instructions without overtightening.
- Refill and check for leaks
Lower the truck and add the specified oil through a funnel, starting below the full capacity. Start the engine briefly, inspect the drain plug and filter for leaks, shut it off, wait for the level to settle, and confirm the dipstick reads within range.
Check your vehicle’s repair manual for exact specifications and fit.