How to Replace Rear ABS Wheel Speed Sensors 05-11 Honda Civic
Difficulty: Intermediate · About 40 min · Honda Civic
Replace the rear ABS wheel speed sensor on a 2005–2011 Honda Civic by supporting the vehicle, routing the new harness through its retainers, and checking the ABS warning light.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Torque Wrench
- Rust Penetrant
- Jack Stands
- 19mm Socket
- 10mm Socket
- Ratchet
- Floor Jack
- Needle nose pliers
- Trim Tool Set
- 1/2 Inch Breaker Bar
Parts and supplies
- Rear ABS wheel speed sensor
Steps
Raise the vehicle and remove the wheel
Park on level ground, chock the front wheels, and loosen the rear lug nuts slightly. Raise the rear at an approved lift point, support it on jack stands, then remove the wheel to reach the sensor and wiring.
Remove the old ABS sensor
Release the sensor wire from its retaining bracket and remove the 10 mm sensor bolt. Carefully work the sensor out of the knuckle; use penetrant if needed and avoid levering against the sensor bore. Disconnect the harness and release its body-side clips.
Install and route the replacement sensor
Connect the new sensor harness and route it alongside the brake line through the original retainers. Clip the body-side bracket into place, seat the sensor fully in the knuckle, install its bolt, and secure the wire in its retaining clip.
Reinstall the wheel and verify ABS
Mount the wheel and start the lug nuts by hand. Lower the vehicle and tighten the nuts in a crossing pattern to the vehicle's specification. Start the car and check the ABS warning indicator; scan for codes if it remains illuminated.
Check your vehicle’s repair manual for exact specifications and fit.