How To Replace Rear Power Window Regulator 96-00 Honda Civic
Difficulty: Intermediate · About 75 min · Honda Civic
Replace the rear power window regulator on a 1996–2000 Honda Civic by securing the glass, changing the regulator through the door access opening, and testing the window before refitting the trim.
Tools you will need
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Putty Knife
- Painter's Tape
- 10mm Socket
- Door Panel Removal Tool
- Ratchet
Parts and supplies
- Rear power window regulator
Steps
Remove the rear door panel
Pry off the handle trim and remove the screws in the pull and handle. Disconnect the latch cable and wiring, release the panel clips, lift the panel away, and carefully peel back the water shield.
Secure the glass and remove the regulator
Loosen the two glass-to-regulator bolts, raise the glass by hand, and secure it with painter's tape. Disconnect the motor lead, remove the regulator fasteners, and guide the assembly out through the door.
Install the replacement regulator
Feed the new regulator through the access opening and loosely hang it on its upper fasteners. Install the remaining bolts, connect the motor wiring, remove the tape, and lower the glass onto the regulator mounts.
Reassemble and test the door
Tighten the glass mounting bolts, reinstall the water shield, and reconnect the latch cable and wiring. Seat the door panel clips, replace its screws and trim, then cycle the window to confirm smooth travel.
Check your vehicle’s repair manual for exact specifications and fit.