How to Replace Bumper Trim Pieces 11-17 Toyota Camry
Difficulty: Advanced · About 120 min · Toyota Camry
Replace bumper trim pieces on a 2011–2017 Toyota Camry by removing the bumper cover, transferring the trim, and restoring the splash shield and wiring.
Tools you will need
- Floor jack and jack stands
- 10mm socket and extensions
- Ratchet
- Phillips screwdriver
- Flat blade screwdriver
- Trim tool
Parts and supplies
- Bumper trim pieces
Steps
- Remove the upper and lower fasteners
Release the radiator shield clips and remove the center grille retainers. Raise and support the vehicle securely, then remove the splash shield bolts and lower the shield.
- Release the bumper cover
Disconnect fog lamp wiring if equipped. Release the wheel well locks and screws, remove the grille and headlamp area clips, then carefully pull the bumper edges free and remove the cover.
- Transfer the trim pieces
Remove the Phillips screws securing each trim section and release the retaining tabs. Separate the trim from the bumper cover without bending the tabs.
- Install the replacement trim
Press the replacement trim sections into their openings until the tabs engage. Reinstall the Phillips screws and confirm the pieces sit flush.
- Reinstall the bumper cover
Reconnect fog lamp wiring and align the cover with the body. Refit the wheel well fasteners, splash shield, grille retainers, radiator shield, and clips.
- Check fit and lighting
Inspect the bumper gaps and verify the trim remains secure. Test the fog lamps and ensure the splash shield and wheel well liners are fastened clear of the tires.
Check your vehicle’s repair manual for exact specifications and fit.