How to Replace Window Regulator 01-06 Chrysler Sebring
Difficulty: Intermediate · About 75 min · Chrysler Sebring
Replace the window regulator on a 2001–2006 Chrysler Sebring, supporting the raised glass while removing the old regulator and restoring the water shield and door hardware.
Tools you will need
- 10mm Socket
- Ratchet
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Razor Blade / Gasket Scraper
- Painter's Tape
Parts and supplies
- Power window regulator
Steps
Remove the door panel
Pry away the pull and handle trim, remove their screws and the lower panel screws, then release the panel clips. Lift the panel off, disconnect the latch rod and switch wiring, and carefully peel back the water shield.
Secure the window and remove the regulator
Raise the glass by hand and tape it securely to the door frame. Remove its mounting bolts, the regulator and motor fasteners, and unplug the regulator harness before guiding the assembly out.
Install the replacement regulator
Connect and clip the replacement harness, then feed the regulator into the door. Align the motor studs, hand-start the fasteners, and tighten them evenly before removing the tape and lowering the glass onto its mounts.
Reassemble and test
Secure the glass to the regulator and reconnect the switch. Test the window for smooth travel, then restore the water shield, latch rod, door panel, screws, and trim pieces.
Check your vehicle’s repair manual for exact specifications and fit.