How to Replace Window Regulator 93-11 Ford Ranger
Difficulty: Intermediate · About 50 min · Ford Ranger
Replace a Ford Ranger window regulator by securing the glass, removing the riveted regulator, and checking window travel before sealing the door.
Tools you will need
- 8mm Wrench
- Phillips Head Screwdriver
- Drill
- 3/8 Inch Drill Bit
- Painter's Tape
Parts and supplies
- Window regulator
Steps
Disconnect the battery and open the door
Disconnect the negative battery terminal. Remove the door-pull and panel screws, lift the panel from its clips, and carefully peel back the moisture barrier.
Secure the glass and remove the regulator
Unplug the regulator motor. Drill out the regulator rivets carefully, release the glass from its mounts, and tape the glass securely in the raised position before removing the regulator.
Install and connect the replacement
Guide the new regulator into the door and secure it with suitable fasteners. Plug in the motor, lower the taped glass onto its mounts, and fasten it firmly.
Test travel and reassemble
Reconnect the battery and operate the window through its full range while watching for binding. Disconnect power again if needed, then restore the moisture barrier and door panel.
Check your vehicle’s repair manual for exact specifications and fit.