How to Replace Front Brakes 2016-2022 Honda HR-V

Difficulty: Intermediate · About 75 min · Honda Hr-v

Replace the front pads and rotors on a 2016–2022 Honda HR-V after confirming the brake package and parts by VIN. Keep friction surfaces clean, support the vehicle securely, and use Honda's specifications for all brake and wheel fasteners.

Steps

1. Check parts and prepare the vehicle

   Match the pads, rotors, and any required clips to the HR-V's VIN and trim. Park level, chock the rear wheels, loosen the front lug nuts, then raise and support the vehicle at approved points.

2. Remove the caliper and pads

   Remove the front wheel and caliper fasteners, then lift the caliper clear of the rotor. Hang it from the suspension so the brake hose is not stretched, and note the pad and shim positions before taking them out.

3. Remove the bracket and rotor

   Unbolt the caliper bracket and remove the rotor. If a retaining screw is present, loosen it with the correct driver; if the rotor is rusted in place, use its removal provisions rather than striking the friction surface.

4. Clean and inspect

   Clean the hub face and inspect the caliper slides, boots, hose, and pad hardware. Replace damaged or seized parts and keep grease, anti-seize, and cleaner away from the friction material.

5. Install the new brake components

   Seat the rotor flat on the hub and reinstall the bracket to Honda's specification. Fit the pads and clips in their correct positions, then compress the caliper piston slowly while watching the brake-fluid reservoir.

6. Reassemble and test

   Refit the caliper, torque the fasteners and wheel nuts to the vehicle specifications, and lower the HR-V. Pump the pedal until firm, check the fluid level, then make a cautious low-speed test and follow the brake maker's bedding instructions.

Check your vehicle’s repair manual for exact specifications and fit.