How to Replace Power Window Switch 01-04 Chrysler Sebring
Difficulty: Intermediate · About 3 min · Chrysler Sebring
Replace the power window switch on a 2001–2004 Chrysler Sebring by removing the door panel, transferring the switch wiring, and testing window operation after reassembly.
Tools you will need
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- T20 Driver
Parts and supplies
- Compatible power window switch
Steps
Remove the door panel
Pry off handle and pull trim, remove the panel screws, and release its clips. Lift the panel away, then disconnect the latch rod, lock wiring, and window-switch connector.
Replace the switch
Remove the switch mounting screws from the back of the panel and lift the old switch out. Position the replacement on its locating points and secure it with the screws.
Reconnect the panel
Reconnect the switch, lock wiring, and latch rod. Align the panel with the door and press the clips into place before reinstalling the screws and trim.
Test window operation
Reconnect the battery if it was disconnected and test each window function. Confirm the switch is secure and the door lock and handle work normally.
Check your vehicle’s repair manual for exact specifications and fit.